Hey drone builders and racers! This 30A ESC (Electronic Speed Controller) is a solid upgrade for your quadcopter or DIY drone project. It’s built to handle 2-4S LiPo batteries (that’s 2 to 4 cells) and delivers a continuous current of 30A, with bursts up to 35A – plenty of power for most racing and freestyle setups. Comes with a T Plug (3.5mm) connector ready to go, so you can wire it up without extra hassle. It also includes a built-in BEC (Battery Eliminator Circuit) that outputs 5V at 1.5A, perfect for powering your flight controller, receiver, or small servos. The ESC has smart protective features like low-voltage cutoff (set at 4V), over-temperature protection, and safe start-up to prevent accidents if your throttle isn’t at zero. It’s compact at about 57mm x 25mm x 8mm and weighs just 27 grams, so it won’t weigh down your build. Whether you’re replacing a worn-out ESC or building a new rig from scratch, this little yellow board is a reliable, affordable choice for smoother throttle response and better performance in the air.
