Hey DIY lighting folks! Got an RGB LED strip project and need to split one connection into four? This simple cable from uxcell is exactly what you need. It's a 1-to-4 female connector cable, meaning one end plugs into your RGB LED controller (the male plug from the controller goes into the single female end of this cable), and the other end gives you FOUR separate female connectors. This lets you run power and signal to up to four different sections of your RGB LED light strips from just one controller output. It's made specifically for standard 4-pin RGB strips, like the common 5050 or 3528 SMD types. The cable itself is 30 centimeters long (about 12 inches) and has a white jacket. It's super easy to use – no soldering needed, just plug and play to connect strip to strip or strip to controller. It's a basic but super handy little accessory for expanding your LED lighting setup for under-cabinet lights, behind TVs, in gaming rigs, or for any cool accent lighting. Just make sure your strips have the matching 4-pin male connectors. One cable is included in the package. Super simple, does the job perfectly!
